multiple vlan not working2019-02-06T03:04:02-04:00

Hi All,

We are trying to monitor & control multiple networks. done configuring cisco core as trunk port allowing particular vlans.

on genian side, done configuring as trunk port with sample IP below

# configure terminal
# interface eth0.1 address
# interface eth0.1 gateway
# interface eth0.1 vlan 1,10,15
# interface eth0.1 management-server enable
# interface eth0.1 node-server enable
# interface eth0.1 radius-server enable
# exit

But the problem is, after configuration, we can’t access nor ping the ip please help.



Answered question

Hi Jes,

First, ensure that the trunk port is properly configured. Next make sure that the network sensor is set to host mode to enable vlan visibility.

Let me know if this helps.

Answered question
You are viewing 1 out of 4 answers, click here to view all answers.